Getchipset() Qualcomm Atheros Communications AR9271 802.11n There is NO WARRANTY, to the extent permitted by law. This is free software you are free to change and redistribute it. License GPLv3+: GNU GPL version 3 or later SHELL is GNU bash, version 5.0.3(1)-release (x86_64-pc-linux-gnu)Ĭopyright (C) 2019 Free Software Foundation, Inc. It will give the same information as verbose and add more airmon-ng -debug In this case, the following additional information can be seen: Kwlan0 ath9k_htc-1.4 Qualcomm Atheros Communications AR9271 802.11n mode managed XInterface Driver-FirmwareRev Chipset Extended Info ? indicates we do not know where the driver comes from. S indicates driver comes from the staging tree, these drivers are meant for reference not actual use, BEWARE
V indicates driver comes directly from the vendor, almost certainly a bad thing K indicates driver is from 4.19.0-kali4-amd64 If your system does not support VT-d, you can only use USB wifi cards If your system supports VT-d, it may be possible to use PCI devices This appears to be a VMware Virtual Machine It gives information about the system as well as details about the wireless airmon-ng -verbose You can set the channel number by adding it to the end: airmon-ng start wifi0 9 is running then stop them first prior to all the commands above: Other drivers do not show the MAC address of the card. The MAC address of the card is only shown when using the madwifi-ng driver. The access point shows the MAC address of the card. Also make sure the essid, nickname and encryption have not been set. Link Quality=0/94 Signal level=-96 dBm Noise level=-96 dBm Mode:Monitor Frequency:2.452 GHz Access Point: 00:0F:B5:88:AC:82īit Rate=2 Mb/s Tx-Power:18 dBm Sensitivity=0/3
If you want to use ath0 (which is already used):Īth0 Atheros madwifi-ng VAP (parent: wifi0) (VAP destroyed)Īth0 Atheros madwifi-ng VAP (parent: wifi0) (monitor mode enabled) Tx excessive retries:0 Invalid misc:0 Missed beacon:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Link Quality:0 Signal level:0 Noise level:0 Mode:Managed Channel:0 Access Point: Not-Associatedīit Rate:0 kb/s Tx-Power:0 dBm Sensitivity=0/3 It likely looks similar the following output. After starting your computer, enter “iwconfig” to show you the current status of the wireless interfaces. This describes how to put your interface into monitor mode.
0 kommentar(er)
